If your having trouble with identification, email or call them. Some graphic controllers which are not VGA compatible take the output from a VGA controller and map it to their display as a way to provide boot information and VGA compatibility. If the signal has been triggered, it will record to the CMOS and show the message on next boot-up. Front Panel Audio-out Header This connector will allow user to connect with the front audio out put headers on the PC case. Clear the CMOS data.

Uploader: Nigrel
Date Added: 20 April 2004
File Size: 59.53 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 9324
Price: Free* [*Free Regsitration Required]

Setup default A password is required to access the Setup Utility only.

Biostar N4SLI-A9 – motherboard – ATX – Socket 939 – nForce4 SLI

Each category includes no, one or more than one setup items. Disabled defaultenable. Joined Apr 9, Messages 7, 2. With the Overclock Manager, users can easily adjust the frequency they prefer or they can get the best CPU performance with just one click. The item offers several delay time for you to choose.

The MG flux you have is a rosin-based mildly-active non-halide activated variety, which should have some ok wetting properties but probably not too much reduction potential. Sleep and Suspend power management modes are supported.


Overclock Panel Click the Overclock button in Main Panel, the button will be highlighted and the Overclock Panel n4si-a9 slide out to left as the following figure.

The information will be refreshed every 1 second.

This will only apply if passwords are set from the Setup main menu. Execute the setup execution file, and then the following dialog will pop up. Joined Jan 29, Messages 5, 2. After confirmed, please follow steps below to relief the CPU protection function.

Going to throw all this stuff in my Antec v2 and slap a ton of x38 fans everywhere. Power Saving Minimum power management. The system needs to record and update ESCD to the memory locations.

Always On defaultSmart.

Minimum 1, and maximum is up to 6 or 8. A heat gun is risky unless you can adjust its temperature. Make sure to insert the card into n4sll-a9 slot completely.

EDIT Corrected a brain fart. Supports data transfer rates 1. If your having trouble with identification, email or call them. Prepare two graphics cards with PCI-E x16 interface. Disabled default Disables the function.


Biostar N4SLI-A9 Owner’s Manual |

Check cable running from niic to disk controller board. Load Optimized Defaults This selection allows you to reload n4sli-9a BIOS when the system is having problems particularly with the boot sequence. Power on the AC. The iron I am using is a Weller 40 watt. Confirmation message will be displayed before proceeding. Off Leaves the computer in the power off state. Also you need to practice on junk circuit boards that have at least 4 layers of copper.

All the brand and product names are trademarks of their respective companies. For curiousity I ended up cutting off the damaged capacitor so I could look at both sides, and sure enough the solder doesn’t melt and flow at all with my iron.